using a set of MASTER KIT ” 4-channel microprocessor-based timer , thermostat , clock » NM8036
I applied a set of NM8036 for heating a country house. I is in the boiler , but the use of a heating circuit for all the floors did not produce a good result : the upper floor was warm (even hot) , on the ground floor and in the basement was much cooler.
I decided to apply the three-loop heating scheme for each floor and separate adjustment of heat supply .
Heating country house
As the heated substance I used the hot water supplied from the boiler for space heating. Total used three independent heating circuits for each floor . Management (open – close) valves that open hot water 65 degrees. With the heating system , carried out by a given program of the microprocessor timer NM8036. DS1820 sensors are mounted on the floor of each floor and in the oven . Channel Five ( and sensor ) prohibits the inclusion of any valves and pumps in the oven until the water reaches a temperature of 65 degrees. S. Sixth Channel Launches circulation pump circuits floor in an oven at a temperature of 65 degrees. C and stops at 30 degrees. With a stove.
Renovating an old house – old building
How to make a foundation for the house
Installation of heating in a country house
Seasonal maintenance repairs improvements House
Recommendations preventive maintenance house
Economic feasibility of underfloor heating
How to hide the heating pipes
Heating system cottage
Installing underfloor heating in the new apartment
What is a convector heating and how it works
Heating country house In the category Household repairs Many people are interested in knowledge and learning about many subjects, this knowledge may be vital at some point in your life, attention enough, and dive into more detail more articles and learn more information about Heating country house.