Home >> General Maintenance and Repair >> fix flat roof tapered iso board to fix flat roof

fix flat roof tapered iso board to fix flat roof

Status and lifespan of the roof depends on taking care of her. If you have any defects promptly removed, the roofing material will last a long time. Typically, repair flat roof is in the recovery of damaged roofing. Cracks, faults, air bubbles can be eliminated without changing the total coverage.

Preparation of any repairs always starts with a clean surface from dirt, dust, Moss, Moss, and other formations. If you have to make a patch, the frumpy pieces will only be available on top, then this can be corrected by using a special reflective paint or new bitumen coating.

Eliminating the cracks if you find faults and cracks on its soft roof, then it is possible to do without the use of special tape. Before starting work with the roofing will remove not only mud, but dressing in place of the fault. Further crack applied primer and leave on the hour for drying. After the formation of Brown adhesive tape applied to the crack, hiding a distance much greater than the fracture, to prevent the sprawling. As reeling and packing tape make her leg tightly as possible to the roof. Check that all the ends and edges were glued and had a firm grip of the roofing material.

Eliminate swelling If you found the soft roof of swelling, but under it there is no water, then touch it not worth it. But the swelling on the asphalt roof have to repair. Place education air bubble must be heated using soldering lamps or building dryer. After softening the bitumen repair flat roof the bubble wooden block. If the bubble turned out to be water, it must be cut, release the water, dry it and lay bitumen in its place, warming it. Top it is desirable to apply Putty to seal and special tape.

Replacement of the entire coating Repair flat roof requires updating only the cover is entirely produced using waterproofing with emulsion. The process is not complex. The first thing the roof is cleaned from dirt, dust, MOSS and lichen. Further to the entire surface applied primer. After drying the brush is placed a layer of sealant, fabric, followed that follow the brush. The edges of the fabric must have good overlaps and impregnating sealant. The next layer is applied only after full drying of the first. At the end of the work on another sticky surface applied stone Crumb.

Flat roofs have shown themselves quite an important part of the architecture, its status and the course is much harder to fix than the pitched roofs. If you do patches, unsightly appearance will be available only from the top, and then it will be possible to fix, replace flat roof, build flat roof, fix flat roof leakand it’s roll roofing, downspouts flat roof, fix metal roof, repairing rubber roofs, diy fix, temporary fix, And if until recently flat roofs were mainly industrial, the term smoothly operation of flat roof is directly related to correct errors, which need a lot of material attachment.