Ultrasonic BAKU 9050

Ultrasonic BAKU 9050

Ultrasonic BAKU 9050 designed for intensive gentle cleaning objects in a liquid medium under the action of ultrasonic waves held grout .

As the cleaning solutions can be used: Drinking water, distilled water , weak acid and alkaline solutions , solvents and other chemicals . In that case, if the cleaning solution is caustic , toxic  – using an ultrasonic bath covered metal cover.

The use of ultrasonic baths

Ultrasonic cleaners can be used in jewelry and watchmaking , for cleaning electronic components, pharmacology , archeology, medicine and everyday life .

principle of operation

The principle of operation is based on an ultrasonic bath evenly over the surface of the mechanical action of the sound waves of high frequency, for , as a conductor which serves an incompressible medium .

The most simple , affordable and safe cleaning solution is a mixture of warm tap water with a small amount of household detergents.

If you use dish detergent , with a small interval of time of the bath , you are guaranteed to clean and do not damage the object .

To clean gold, silver and copper products in aqueous solution may be to add a small amount of acetic or citric acid. Purifying copper, should closely monitor cleaning time . Prolonged exposure to acid can damage the object .

To remove items from iron oxides , carbon alloys , citric acid can be used , selecting the duration of treatment depends on the thickness of the oxide layer .

Features ultrasonic bath BAKU 9050

– Two modes of power : 30 W and 50 W

– The maximum capacity at the level of the more expensive models

– Easy timer in minutes ( in contrast to many models where time is in seconds )

– The duration of the timer 60 and 30 minutes depending on the power

– Ample working capacity , with compact dimensions

Ultrasonic BAKU 9050 instruction

Place the tub on a hard surface , put in a working capacity of the items that need to be cleaned. In some cases, such as for coins found in the ground, can be poured on top of them a small amount of detergent, and only after a while to fill the tank with water .

Fill the container with water : You can use both cold and hot water. In an ultrasonic bath in a network , choose the power by pressing the 30w or 50w, after clicking on the displayed number “1” indicating the duration of 1 minute brushing , click and hold the «50w» to set the cleaning time ( 30 min) , after installation press the ” 0 / I». To switch to a different mode or stop working , go to another mode of power.