do it yourself Toilet Installation

How to install a toilet bowl, Before you start installing the toilet bowl, you have to correctly pick up. To do this, pay your attention not only to the design of the barrel, but the angle of release. The angle of release should be chosen depending on the features of your drain.

How To Install A Geberit Wall-Hung Toilet Carrier With Flush Actuator Video
This is an exceptional video from Geberit that shows the proper installation of their concealed wall carrier to allow for a wall-hung

TOTO AP or EP Wall-Hung Toilet Installation Video
Installation video for the TOTO AP WASHLET+ Wall-hung toilet. With the optional Auto Flush.

Wall hung toilet installation Video
Wall hung toilet installation A few tricks and tips to make your bathroom installation a whole lot easier. See how to connect the ..

What tools will be needed: Wrenches, Flat and Phillips screwdriver Hammer, Hammer drill and hammer drill. Dismantling.

Before installing the new toilet. Will need to make the dismantling of old. First you need to shut off the water, and then begin scraping off the old unit.

How to connect to the sewer?

First you need to decide the subscribing option, they can be as follows:

A direct connection to the sewage system.
Using a hard pipe.
Using the corrugated pipe.
Once you have decided the way you can move on to the next step.

Ways of fixing the toilet to the floor:

Installing on a tile or a cement Coupler. To do this, use or fixing dowels. With the help of glue. The toilet is planted right on the glue, but you should consider that its removal without damaging the toilets would be impossible.

do it yourself Toilet Installation

Installation on a wooden board. To do this, you need a strong Board and screws. Before that process the Board special solutions to protect against decay.

Installation and connection

Put on the place where you will install the toilet, a layer of sealant. This is necessary in order to remove possible irregularities of the floor. Then put the toilet and is tightened with screws depending on the method of fastening. Further, is to connect the water barrel.

Leave a Reply

Your email address will not be published. Required fields are marked *