Install plumbing systems installation

Install plumbing systems installation – System installation is a structure of metal profiles, allowing successfully install overhead plumbing. This ergonomic and functional design will save space of your bathroom or toilet, which is especially important for small spaces typical of city apartments. Our article will tell you about the installation of the new toilet installation system for profiles.

Installation systems come in different firms. They differ in width tank and frame: from 38 to 57 cm height-adjustable support legs are attached to the floor system. The adjustable depth of support fastened to the wall.

It should be noted that all system installation method combines reservoir mounting. Tank is fixed to the frame, which makes it possible to hide it, with water pipes and tap – in the well of the central riser. On all sides the system is arranged in planes, which allows her to sheathe, such as plywood or plasterboard. Flushing systems are equipped with keys of different colors.

Remove the old toilet

How To Remove A Toilet Review

Once removed the old toilet and broken partition separating the bathroom or toilet from the well with the riser (main pipe), you need to try as suitable new toilet drain to the old drain. Usually not suitable. In this case, you need to remove the extra pieces of pipes (usually iron pipes or tees).

It happens that by knocking out the old lines, creates vibration, which leads to undesirable consequences. So, if a neighbor through the wall, the toilet is connected to the pipe rigidly, ie, the old cement is packed, it can also split in runoff. Work carefully and take care of the property neighbors!
By knocking out unnecessary segments remember that iron is very fragile, and the remaining filler pipe should be kept intact. It is advisable to use the grinder (electric saw with a rapidly rotating abrasive cutting wheel).

Removing all unnecessary, remove any remaining cement neck and insert the rubber gasket.
Pick plastic knee so that a new toilet drain was as close as possible to the center tap of the riser with the oversight of the new plastic pipes. In this case, you can use the coupling short corrugation – at the junction will not kink.
It should be noted that they brought to the tee stock with washbasins and bathtubs. Better to remove the iron and put the plastic. With plastic piping is easier to work, as there is the opportunity to stock with a maximum slope that will not get clogged.

When the drain pipes are installed, proceed with the installation frame system – secure the dowels to the floor and wall.
Fit the flow of water from the tank to the toilet bowl. To do this, cut the pipe (which is sold in the kit) to the size of the recess in the toilet before turning on the vertical section.

Screw the studs into the holes of the framework. Insert the pipe connections (water supply to the toilet) and align segments runoff.

Hang the toilet on the studs

Fitting And Installation Of Concealed Cisterns For Wall Hung Toilets Review

Put the plastic sleeve and tighten the nut.
Connect the water to the reservoir via an adapter to solve smaller diameter hose. Finally, adjust the water dialed.

Tip:

No need to save the filter, because the typesetting system of water in the reservoir is quite complicated: If it gets into the valve that works with tiny particles float, valve stops functioning.
However, you can disassemble and clean the valve. To do this:

flushing to remove key (in other words, button);
disconnect mount float;
turn the tap cover counterclockwise 60 ° and remove it;
rinse with tap cover (it is on this cover over the membrane is going dirt that does not work normally tap);
reassemble the faucet.
Please note that you need to carefully disassemble the faucet. All parts are made of plastic, thin and fragile in some places.