genie garage door parts phoenix

Automatic garage doors have become an integral attribute of a modern garage. The novelty very quickly conquered the market, and greatly simplified the life of motorists. Now, to open or close the gate, you do not need to get out of your car. This can be done directly from the interior of the car.

Frequent problems and breakdowns

The gate is very convenient to operate. Only their frequent use leads to certain breakdowns. In the process of operation, the hinges are subjected to rapid wear. The load on them is not small, and over time they begin to bend, thereby interfering with the normal operation of the flaps and automation.

When the gate is made by non-professionals or independently, the owner may be touched by the problem of sagging flaps. This happens because often inexperienced “specialists” simply weld a piece of metal onto a rectangular frame, forgetting to strengthen it with crossbars. In the process of operation, the frame deforms from a heavy load, and the sash begins to sag.

In addition to mechanical breakdowns, other factors can disable the automation of garage doors. Those that affect the electric drive. Often the result is as follows:

The drive stops responding to the commands of the control panel.
Commands from the remote control do not execute correctly.
In the drive there are noises that are not characteristic of it.
If any of the above-mentioned problems are detected, measures should be taken to eliminate them immediately. Timely repair of automatic garage doors will help to avoid unnecessary costs for replacing the electric drive in the future.

We eliminate breakdowns

Has the automation failed? Check the integrity of the box on the control unit. If it is damaged, then you will need to reconfigure the automation or replace the board. During power surges, the fuse may burn out. If this happens, you just need to change it to a working one. Dried lubrication in the drive will lead to the appearance of uncharacteristic noise and a malfunction in the operation of automation. The problem is solved by carrying out lubrication, reconfiguring the equipment and replacing the electronic board.