How to keep electronics in working condition after water damage

How to keep electronics in working condition after water damage – Yes ! You can save your electronic stuff after water damage that’s the way Recovery electronics after hitting dropped the phone in water . Follow these simple tips and you will be able to return to normal operation your mobile phone , mp3 player or even a laptop, as well as any other electronics .

First, once you discover that your email “friend” too humid or wet, immediately turn off the power : unplug it , remove the batteries , remove all available for removing parts ( front and rear panels , antennas , cords, cables etc.). If you can disassemble the appliance in the home – do it with care to prevent it from further damage. Use a soft, clean, lint-free cloth for gentle removal of moisture on each of the components of electronics Recovery after exposure to moisture.

device, and then place them separately. Also wipe all the cavities and crevices in the product. To remove moisture from small parts where you can not use a cloth that you can use a hair dryer to heat the minimum mode . This will cause drops of water to reach the surface , where you can use a soft cloth to remove them. Be careful not to let parts of the device to heat up – use a hairdryer to dry at least 10 centimeters , and take frequent breaks to avoid damaging parts excessive amount of heat. You do not want to save your electronics from water and thus spoil it overheating ?

After careful drying and complete removal of moisture from all parts , electronics Recovery after exposure to moisture. Lay out all parts of the device in a dry and well-ventilated place at least 24 hours . You can also use a fan to dry the final details. Occasionally turn the items to check for moisture and to remove them to perform on moisture. Do not assemble the device and do not connect the power supply , at least for 24 hours. You should make sure that all parts are thoroughly dry , but the longer they stay wet , the longer they should be dried .

If after drying for 24 hours on the details do not constitute an additional moisture , you can safely collect the device . Collect items together leisurely and carefully , electronics Recovery after exposure to moisture. checking every detail for the presence of traces of moisture and oxidation. Traces of oxidation , if any, is also thoroughly but gently remove with a soft cloth . Finally, when your device is fully assembled again , you can insert batteries or connect it to the network. Your electronics should be ready to use after all of the above actions.