Correction of defects in your garden

Correction of defects in your garden

In horticulture, there are so many things that influence the growth of plants. In other words, there are so many things that can go wrong. Collectively , they are known as the factors influencing growth . Having an understanding of each growth factor , you will be able to identify and correct all conditions in the garden before they become a problem.

In order to get the most benefit from this information , you need to understand what your gardening at home to be successful as much as factors allow it to be so . It is sufficient that only one factor out of control that it has led to problems . Knowing the ideal limit for each growth factor and being able to support each factor within these limits , you will come to maximize plant growth and maximum yield .

When there is a problem of unknown origin , the list of growth factors becomes an invaluable tool. Checking the condition of your garden through the list of factors affecting the growth from the beginning to the end, you will be able to identify the source of any problem. The factors influencing the growth in any garden are:

1. Time – you have no control over time itself , but you need to understand the role that time has on each of the other factors. When growth factors outside of allowable limits , the level of damage depends on the time.

2 . Temperature – most house plants grow best at temperatures between 20-23 degrees. Many factors , such as temperature preferences will vary slightly from plant to plant .

3 . Humidity – most house plants prefer 50 % humidity , plus or minus 10 %. Some plants , such as orchids prefer a higher humidity . Other plants , such as fruiting tomatoes, can rot the roots , if the humidity is too high .

4 . Water – in the water, which you will water the plants , should contain no more than 150 parts per million ( ppm ) of salt and sodium carbonate . If the tap water in your area is not acceptable , then you can either install the purification filter , or to use distilled water.

5 . Light – most fruitful and flowering plants need good light enough (50-80 watts / sq.m . ) . However, these same plants will grow well under a light at 25-40 watts / sq . Some houseplants lighting needs even lower. The more light , the more commonly needed power plants.

6. Power – the most complex of all the factors affecting the growth . Food plants consists of primary nutrients secondary nutrients , micronutrients , hormones , enzymes , carbohydrates, and other elements . The nutritional needs differ not only between plants , but also for a plant when it passes from seedling stage to the vegetative stage and ultimately to the flowering stage .

7. Hydrogen index (pH) – if you grow Uzambarskie violets, you may need acid soil , but most of flowering and fruiting plants require “soft” soil (slightly alkaline) . It depends on the fact that 98 % of the plants on the ground have a symbiotic interaction with beneficial micronutrients that best survive the hydrogen index in the 6.2-6.5 .

8. Oxygen – in the root area of ​​the plants need oxygen . Consumption of nutrients occurs only in the presence of oxygen. This means that if you are over- watering the plants, they will not be getting any nutrients . That’s why you have to have air bubbles in the source of nutrients.

Carbon dioxide – carbon dioxide for the plants is like oxygen for humans. In the center of each plant cell contains carbon molecule , mainly produced from atmospheric carbon dioxide . In fact, if all other growth factors will be in the ideal range , carbon dioxide is the growth limiting factor. It was noted that in a well groomed gardens observed 50% increase in yield by adding carbon dioxide.

Pests – refer to pests such as insects mites and thrips, but also pathogens. These microbes are the cause of root rotting , mold and other nightmares. Many of these pests are very, very small. It is necessary to carefully examine the plant to eliminate them as a possible source of problems.

Leave a Reply

Your email address will not be published. Required fields are marked *