Home >> Printers & Printer Accessories >> Basic maintenance of a laser printer

Basic maintenance of a laser printer

In the majority of cases we never pay attention to our printer more than when just us toner and paper; the same printer itself leaving completely forgotten. If we want an impressions with good quality apart from using a paper and a consumable right, we must maintain in perfect condition the printer.

The care that we have with her is basically cleaning, to this installed on a clean environment made that laser and its lenses from becoming dirty which, if it happened, would lead to a clear print on sheets that would make us think that the consumable toner is malfunctioning or is virtually sold out by mistake. Still, although the working environment is clean, by normal printer is going fouling contained in the cartridge toner powder; so in any case, it is recommended to clean the inside of the printer regularly.

Example of dirty printer printing

Latex gloves
Brush about 2 cm of width
Vacuum cleaner
Mask (optional depending on soil level of the printer)
Cotton cloth that does not leave lint
Alcohol

Clean a printer laser, fax, or copier toner is very simple. Before you start cleaning we will follow some basic safety rules:

Make sure this printer turned off and disconnected power cable.
Not have printed nothing in the last 10 minutes because there is risk of burns from the printer fuser.

Basic maintenance of a laser printer

Once we have done previous checks proceed to cleaning in the following way:

Remove the tray paper feed and all over the inside of the printer consumables.

Using the vacuum cleaner and brush go sweeping toner and inner dirt that is on the inside while we sweep the mouth of the vacuum cleaner will be right next to the brush to go collecting toner.

Once I clean all the inside of the printer with the vacuum cleaner, clean the electrical contacts with a cloth moistened with alcohol. We will gently clean without exerting excessive pressure on them to not to deform them.

Finally go to the gap that we have left when removing the paper tray, on this hole will locate a roll of rubber, usually grey. We clean this roller paste with a cloth moistened with alcohol. It is important to clean this roller, since dirt can cause paper jams or one ugly stain black at the top of the paper.

watch also: HP LaserJet 4250 Maintenance Kit Instructional Video

Done once these processes again install consumables and paper tray, connect the printer and ready to print. This simple operation is convenient to perform it every time we were exhausted a cartridge so that our impressions have the same quality as the first day.

Basic maintenance of a laser printer In the category Maintenance and repair Many people are interested in knowledge and learning about many subjects, this knowledge may be vital at some point in your life, attention enough, and dive into more detail in regards to Basic maintenance of a laser printer.

Basic maintenance of a laser printer

Tags: , , , , , , , , , , , ,

Leave a Reply

Your email address will not be published. Required fields are marked *