Repair self-leveling floor

Repair self-leveling floor – it is rather the elimination of the consequences of incorrect installation procedure than routine maintenance . Properly leveling floors bathed coating is usually a few decades , so the best solution – once to make qualitatively floors and forget about them at all. But if and climbed defects, rush should not be upset , because , most likely, will solve the problem . Although, of course , sometimes violation floor molding technology makes it completely redone. Well, do not let the bad , and better understand the causes of defects , as well as find out how to get rid of them .

Types of defects sexes and their solutions

Delamination and flooring usually occurs in cases where the basis for the application of the composition prepared correctly. For example , there is no waterproofing or its integrity compromised and penetrated into the water , brand strength of the concrete is too low and it crumbles before applying foundation was not properly dried or as its surface was not tipped. Repair self-leveling floor with such a defect is to dismantle the problem area , the substrate and re- pouring a new floor . Sometimes during the repair of an apartment with his hands , you can try to lift who quit layer thoroughly clean up the surface beneath it , and then glue it to the base with mastic . However, such procedures do not solve the problem , but merely postponed its decision for several years. Ideally, of course , coverage dismantle troubled place and pour the floor again.
Cracks on the surface of the topcoat no cracks do not occur in the base , and they are a continuation . Therefore, to fix the problem is only one way . For this it is necessary to embroider crack in all its depth , primed , fill the special repair of polymer composition and apply a new layer of self-leveling floor .

Peeling and premature wear leveling floors appears in consequence of the application of a surface layer on a poorly prepared or muddy ground. In this case, repair the floor will be to sweep the surface and applying a new composition. However, through time, the problem will appear again , so it is important to pay due attention to the training base. But sometimes self-leveling floor surface may simply not withstand overly active operation and only to be replaced by a more solid .

Roughness of self-leveling floor , as well as ” grains ” on its surface can be removed by sanding and applying a new layer . Cause of these defects is too high viscosity of the composition , so when it re- application is necessary to reduce the viscosity . Generally it is important to ensure that the composition was prepared in the correct proportions , and otherwise on the surface roughness may appear in addition to more and stains .

Depressions on the surface of self-leveling floor can happen when a heterogeneous composition . However, they repaired easier. You can use ordinary putty . When it is dry we put a new layer of coating and problems gone.

Stickiness of the floor – it’s a bad sign. Most likely, in the preparation of the ingredients were bad stir or selected the wrong aspect ratio . Output in this case, only one – complete dismantling and cover defective areas.