Polymer Flooring System a decorative Finish For Concrete Floors

Polymer Flooring System a decorative Finish For Concrete Floors, How to Make Polymer Flooring, You yourself have started to repair or raised old linoleum and saw that the floor is not so good as before. In order to restore it to do brandy floor. What measures should be taken to restore the sex? For work will need the following tools: drill, metal brush (also used grinding machine), two-meter rack, rack, roller or spray paint, construction vacuum cleaner, dry mix for floor leveling and trowel. There is an article on how to choose laminate.

Thus, all the tools are available, you can begin to do the work. Start with foundation cracks at the base of the floor, then check equality surface using long rails. You must know that the distance between the rail and the floor should not be more than 2 mm After the inspection set floor level, with existing plaster on the walls, remove it to 3 cm above the specified level. Thoroughly clean surface wire brush and vacuum accumulated dirt.

Using a sprayer or roller, perform single-layer coat with a thin layer. It is important to comply with this condition, so re-priming belongs. Then laid along the walls and wooden slats can be considered the foundation floor ready to distant work.

Then we start harvesting the mixture to be used when casting the floor. With constant stirring, the mixture is diluted with water. Once the solution is smooth, we begin to fill the floor. It is better to work with someone in a pair, as ready-mix can not be left for long.

Installing Cromfloor Polymer Flooring System

A Decorative Finish For Concrete Floors
CROMFLOOR Polymer Flooring System is a waterborne, decorative finish for domestic and commercial concrete floors. It is economical, hard wearing and easy

 

Fill beginning to do with the far corners of the room, gradually heading towards the door. The solution is to fill the width of the strips 30-50cm. Using a spatula for even distribution of the solution on all floor. After the work done give the floor to dry. It is necessary at this time to the room was closed and protected from direct sunlight, drafts impact and temperature changes. After finishing 7-11 hours you can begin stepping on the floor made​​. Complete drying will take place only after 2 days.

Arizona Polymer Flooring (apf) Company

Arizona Polymer Flooring (APF) manufactures high-performance flooring products and concrete coating systems using advanced polymer chemistry.

After three days, it is already possible to begin to conclude stove, a week laying the panels. “Warm floor” can not begin to do a week before. It should be remembered that the floor heating, you have to start with room temperature, increasing it to 3 degrees per day.