Plastic fillings for walls and wood

The plastic fillings is a type of putty to the water white, useful for correcting imperfections in walls and wooden objects like doors, windows and furniture. It is also used on walls. Usually apply one or two coats of fillings and rear sandpaper, to achieve a completely smooth surface.

 

This material should not be used to fill holes textured surfaces where layer applied is greater than 1 mm in thickness. This is the maximum application of the material. Another type of solutions, such as cement or other types of fillers are used for major imperfections.

Mode of use of the fillings

It can be applied on site to repair with putty knife or trowel. The surface must be dry, free of dust and loose parts. If you improve a new wall with plastic fillings this must be completely dry, waiting for approximately 50 days since its completion.

Before and then to the application of the material it is recommended to apply a coat of fixative sealant into the water, only in walls, for the correct adhesion of the putty.

The stucco work is very rigid when drying, is not flexible, not to join the walls a constant work of contraction and expansion, therefore is not usually effective on cracks caused by the movement of structures. A flexible material for cracks should be applied in these cases.

Outdoor plastic fillings

The plastered Interior, or common, has no resistance to moisture, extreme heat or cold, so in these cases is necessary a special outdoor material. Some manufacturers to put on the market a plastered exterior that tolerated a little more agents.

To do a good job with this material, you apply before and after the repair with plastic fillings for outdoors, a coat of sealant fastener to turpentine that proof material for its longevity.