Laser Levels laser construction technologies

Laser Levels . What’s new in the world of laser construction technologies ?

The advancement of technology increases the ease and accuracy in the work force, now a laser beam to determine the level of the internal construction or outdoor use, is used in the implementation of the business professional, such as tiling, installation of doors, floor levels, etc.. Gives a horizontal laser line and vertically, many uses of this device, which saves time and effort.

Over the past 5 years on the market laser levels have been some significant shifts in the direction of increased functionality , which are mainly related to the new patented solutions company BOSCH …

Last year, Bosch introduced the world to its new range of laser with beam splitting prism, not a 120 or 160 degrees, as it was before, but at 360 degrees, which allows the design of a plane at 360 degrees around the device , ie indoors on all 4 walls!

First came Levels GLL 2-80 P and GLL 3-80 P, respectively, which build 2 or 3 full 360 -degree plane , in consequence, there was also a consumer model PLL 360 with a single plane of 360 degrees ( horizontal ) .

The technology is simple, if you previously cleaved prism beam in one direction, and levels could only work in front of the device , but now with the new models of laser levels builder planes Bosh can turn the unit in the middle of the room and carry out work on all the walls at the same time .

Also positive, which greatly increases the accuracy of work because when moving the leveling off the wall to the other , as a rule , the beam gets off and set it one-to- one almost impossible , the error will be larger than when working with new models.

Some manufacturers , in order to keep up with fashion , began to make devices with multiple (up to 6 emitters – diodes ), which are also building a plane in the horizon of 360 degrees, but there is one thing : if one of the diodes goes astray , the accuracy of the leveling work ceases questionable and to calibrate the entire instrument at the service center .

With new leveled by BOSCH GLL 2-80 P, GLL 3-80 P 360 or the PLL will not happen , because You yourself can always check the accuracy of the device , for example, after a fall, just place the device – make a mark on the wall, then rotate it 180 degrees and check the coincidence of the beam. If the Rays match, then the device is operating normally .

Of course , as before , the manufacturer recommends to contact the service centers 1-2 times a year in order to calibrate the device , then you can always be assured of a laser instrument readings . It is also recommended after serious falls to check the instrument in the service, in order to prevent further release of device failure , you ‘re not always able to visually identify the failure .