When and how to install a split system before or after repair

Split system should be installed prior to or during the repair. If you plan to conduct serious work, which could damage the device, then the system must be mounted immediately after these works, but even before the end of the last phase of decorating. This will be the ideal option, so as to avoid the appearance of dust and debris, drilling walls fail and unlikely the owners apartment or House will be nice to watch as the ideal wall are drilled with a drill, and floor covering spoils crumbs, dust and debris. If the installation of split systems is carried out after the repairs, the residents must be prepared to face the necessity of carrying out general cleaning, drilling, grooving walls and etc. If you exert maximum efforts and act carefully, then a lot of damage to repair the damage will not be.

Today, as a rule, installation of split system produced by the company, which had purchased the air conditioner. But many consumers with success and no less efficiently conduct all work independently. So when and how to install a split system, everyone chooses their own.

As a rule, installation of split system begins with the installation of the inner block. In this case, the big advantage is that virtually all modern air conditioners have a removable back wall that can successfully be used as a stencil to place mark places future drilling, eliminating errors and drilling extra holes.

In order to fulfill the apertures in a wall, you need a lightweight hammer, who owns label SDS +. It is possible to use usual drills, and will take more time. When you install the internal unit air conditioner it is important to remember about some nuances. Unit shall be placed strictly horizontally so that the condensate shed with pallet in hose for drainage instead of dripping on the floor. Checked this option by using a level. The important point is the installation of the housing block split system-it must be firmly diagnosed in attached to the wall of the back cover in order to air the most densely Shute is tight to the wall.

Strengthen the internal unit air conditioner need a special mounting plate, which comes with air conditioning. Choose a location for mounting the need very careful-if the drilling of new holes does not represent labor, then move the air conditioner after you have laid all the wires and hoses, there is quite a challenging task.

Experts note that the correct choice of location for the installation of the internal block is of great importance. You can not install the unit in the following places: above sources of heat (this may affect Termini device); in places where regular working devices, which create electromagnetic high frequency oscillations (it can knock down the CPU settings); over work places and beds (to avoid ARD). Also, you should not install the internal unit in a place where marked by difficult air circulation. The distance between the air and the subject that closes it, should not be less than 2 metres, otherwise the system will be unable to maintain the preset temperature.

For the installation of outdoor unit split systems holes for anchors mounting brackets. When choosing a location for installation of the external unit must pay attention to the availability of places-here should be easy to maintain the air conditioner. The wall should be strong, and when choosing the brackets and bolts, which will be mounted outside the unit, paying special attention to the reliability and weight, which can withstand the fastening elements. In choosing to focus on the following rule: maximum weight that can theoretically withstand mounting the air conditioner should not exceed the real weight is fixed block in 2-3 times.

Do not install the unit on the glazed balconies or loggias-system will be enough air, it quickly fails, will warm the loggia. In this case, better pin block under the window. For residents of the last floor a good option is the installation of the outdoor unit on the roof, but we must remember that the difference in height between the internal and external units must not exceed 3 meters. If the system is installed in a housing on the first floor, you can install the unit at a height of 1.8-2 meters above ground level, and then close it the ethmoid cells. Once the internal and external units are installed, you need to check the strength of the anchorages, conditioner-it should not vibrate, the design should not wobble.