Flash a digital demodulator

Flash a digital demodulator , all you need to know

Digital demodulators sometimes require an update of their software is flashing . You can perform this operation yourself , without the need to seek professional help . To succeed flashing , simply have the necessary equipment and follow a few steps . It should also concentrate well throughout the whole operation to avoid mistakes that could damage your device.

The digital demodulator also known as the common name “decoder” is a device that has two functions: digital demodulation and decoding. To pass the flash of a digital demodulator , it is important to understand certain processes and have some concept in computer science. It is also necessary to have the necessary equipment. Flash a digital demodulator is to update the data on your device either directly by satellite or by downloading the latest version available online. To help you succeed in this task, the software comes with a document that contains the instructions.

Flash a digital demodulator : materials

For successful operation, it requires a minimum of equipment : a computer with an RS- 232 input , an internet connection to download the new version of the software demodulator software compression and decompression ( winzip or winrar ) and an RS-232 cable to connect the computer to the digital demodulator . You should check how the device behaves vis-à -vis the computer before selecting the type of cable to use: master [Data Communication Equipment (DCE) ] or slave [Data Terminal Equipment ( DTE) ] . If both devices have the same characteristics ( DCE / DTE or DCE / DTE) is a string ” Null Modem” to be purchased to connect . Otherwise , take a ” modem crossover cable ” to connect. Normally, each digital terminal is equipped with an RS- 232 connector with a 9-pin serial port ( DB-9 ) at the rear. Other receivers are sold with a 25-pin cable . You can also find adapters on the market.

How to flash a digital demodulator ?

Once you have gathered all the necessary equipment , you can put to work. Must proceed step by step to avoid making mistakes that could destroy your digital demodulator . Use cords and cables to connect the computer to the digital demodulator . It must be in standby mode. Visit the manufacturer’s official website and download the Loader that it is the software that allows you to install the new software digital demodulator through your computer. Once the download is complete , extract the ZIP or RAR file in a new folder. Select the port that is connected to the receiver, and then click Next (or next) . You will then receive a message that will warn you of the success of the operation. Your receiver is then updated and it ‘ll just plug it into your TV to enjoy your favorite shows again .

Flash a digital demodulator : Some Recommendations

It is not advisable to download the software on unofficial sites that are not approved by the manufacturers in order to avoid damage to your terminal . The unzipped files should be grouped together in a folder . Do not forget to check the type of connection that is suitable for connecting the digital receiver to the PC . Also remember to protect yourself from any power interruption , which could damage the device manufacturers do not guarantee these circumstances accept liability before this event .