DIY Video: how to install a shower and Bathtub

The bathtub is arguably the most important feature of any bathroom. The task of installing the bathtub can be such a great job. Installing the bathtub may have more reflection on then one would think. If you’ve wondered how to install bathtub may think that you can accomplish this task by yourself, but there are several things that you need to keep in mind to ensure that your bathtub is installed correctly. It is very important to think and be open to a lot of other suggestions on how to do it.

Walk in shower designs for any bathroom

What to use to remove the limestone shower ?

how to clean a clogged shower head

Tools for installing a bathtub

Installing a bathtub is not always as large renewal project. First, you should ensure that your aquarium comes with apron and legs and of course tank, Centre of bath. Then you’ll need a tape measure, pencil, ruler, and spirit level, screw flat head with prices, the siphon hole saw. To install, you will need a healthy silicone sealant gun cartridges.

Installing Bathtub Hand-held Shower Head

Linked legs

You can install the bathtub is really very difficult, but because of all the knowledge and the right tools, this can be a success, definitely. Installation of Hammam starts with mounting feet. To do this, put your bowl upside down and use a level to check the leveling of the bathtub. Then, attach the adjustable feet in four pilot holes with a screwdriver. While screwing feet sink, you can use the mounting bar with nuts against for accuracy.

Faucet installation, venting and overflow

There are two basic types of bathtubs you can install: outdoor traditional or framed bath tub freestanding claw foot tub-like. When deciding which type you want to install, to install the valve, you will need to make a hole in the space provided for this purpose. Then press the two hoses in holes dug for you only after the screwed Rod threaded under the tap. But before you install the hoses and fittings at last, place the two mattresses between him and sink. Regarding the installation of the evacuation, you will simply need to connect the drain to the trap and screw them to vent with ring clamping. Finally, move the overrun in the opening provided for this purpose by turning trim on top.

A bathtub

You want to make sure to do it right the first time and this is one area where you don’t want to make any mistakes. Before asking the sink, consider connecting the pipe to the overflow by connecting to the drain by links from the rubber. When you install a foot valve and bypass vent, you can repair the tank on the wall with the wall brackets and silicone joints after checking Plumb tub with bubble level.